Philips Onis 200 - Page 14

Additional Onis 200 handset
14
English
Telephone troubleshooting...
PROBLEMS
The HANDSET icon does not flash
when the handset is placed on the charger.
No dial tone.
No ringer.
The icon is not displayed.
When adding a HANDSET to the BASE
STATION, a “Failure” message is displayed on
the HANDSET.
Interference during the call.
REASONS
- Poor contact.
- Dirty contacts.
- No power.
- The HANDSET is not sufficiently charged.
- You are too far away from the BASE STATION.
The ringer is deactivated.
- The handset has not been registered.
- No mains power.
- The HANDSET is too far from the BASE
STATION.
The procedure used to add a HANDSET to
the BASE STATION has failed.
The maximum number of handsets (8) has been
reached.
- You are too far away from the BASE STATION.
- The BASE STATION is too close to
electrical appliances, reinforced concrete walls
or metal door frames.
SOLUTIONS
- Move the HANDSET slightly.
- Clean the contacts with a cloth moistened
with alcohol.
- Check connections.
- Charge the HANDSET.
- Move closer to the BASE STATION.
See “Ringer settings”.
- Begin the handset registration procedure
again (page 4).
- Check connections.
- Move closer to the BASE STATION.
Disconnect and connect the BASE
STATION mains power supply. Begin the
handset registration procedure again (p. 4).
- Move closer to the BASE STATION.
Check the range.
- Move the BASE STATION to find a better
position (the higher the better).