Philips Perfect Draft HD3620/20 - No Foam on Beer; Too Much Foam on Beer; Parts List

HD3620/20
9-13
REPAIR INSTRUCTIONS
Problem Cause Repair solution
9 No foam on the Beer. Check the following conditions. 1. Temperature of the Beer must be below 9 °C.
2. Glasses have to be clean.
3. Beer tube connector is not properly installed
or is damaged.
Check DFU for more tips.
10 To much foam. Check the following conditions. 1. Temperature of the Beer must be below 9 °C.
2. Beer tube connector is not properly installed
or is damaged.
3. Check if there is no air leakage in the system.
4. When the keg is almost empty it is possible
that only foam will come out.
Check DFU for more tips.
PARTS LIST
Pos Service code Description
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
9965 000 44301
9965 000 44302
9965 000 44303
9965 000 44304
9965 000 26126
9965 000 32659
9965 000 44305
9965 000 26122
9965 000 44306
9965 000 26124
9965 000 26123
9965 000 44307
9965 000 44308
9965 000 44309
9965 000 26117
9965 000 26115
9965 000 26116
9965 000 44310
9965 000 26111
9965 000 44311
9965 000 32874
9965 000 26110
9965 000 26109
9965 000 26119
Back cover
Right Door assy
Left Door/display assy
Connector/Lever assy
O-ring 11X2 Air inlet side
O-ring
Handle assy
Handle O-ring
Tap unit
Spout O-ring
Spout
Steel driptray cover
Driptray
NTC sensor assy
Pressure sensor PCB assy
Grommet. Pump position
Pump assy
Power supply HV 220 - 240 V
Micro switch assy
Main PCB
Drop ring
Grommet, FAN position
Fan assy
Peltier assy