To activate the intelligent automatic steam mode, press the intelligent automatic steam button on top of the iron
handle. The intelligent automatic steam light turns on (Fig. 6).
The `iron ready’ light moves back and forth when the iron is moving.
Note: in intelligent automatic steam mode, steam comes out automatically when you move the iron and
stops when you stop moving the iron (Fig. 7). You can still press the steam trigger in this mode to activate
the steam when the iron is not moving.
You can use the intelligent automatic steam mode in all steam settings, including ECO and MAX.
Note: for your safety, in intelligent automatic steam mode, the steam stops when the soleplate is tilted.
To exit the intelligent automatic steam mode, press the intelligent automatic steam button. The intelligent
automatic steam light turns off. You need to press the steam trigger to continue your ironing.
Steam boost function
The steam boost function is designed to help tackle difficult creases.
– Press the steam trigger twice quickly to activate the steam boost function. The appliance releases 3 powerful shots
of steam (Fig. 8).
Vertical ironing
Hot steam is emitted from the iron. Never attempt to remove creases from a garment that someone is wearing. Do
not apply steam near your or someone else’s hand. You can use the iron in a vertical position to remove wrinkles
from hanging fabrics.
(1) Hold the iron in a vertical position, press the steam trigger and touch the garment slightly with the soleplate (Fig.
9).
Note: for your safety, the intelligent automatic steam mode is not available for vertical ironing.
ECO setting
By using the ECO setting (reduced amount of steam), you can save energy without compromising on the ironing
result.
– Press the ECO button. The green ECO light turns on (Fig. 10).
– To deactivate the ECO setting, press the ECO button again. The green ECO light goes off.
MAX setting
For faster ironing and a higher amount of steam, you can use the MAX setting.
1. Press and hold the on/off button for 2 seconds until the light turns white (Fig. 11).
2. To deactivate the MAX setting, press and hold the on/off button again for 2 seconds until the white light turns
blue
Auto shut-off
– The appliances enter the standby mode if it has not been used for 10 minutes. The light in the on/ off button starts
to flash (Fig. 12).
– To activate the appliance again, press the on/off button. The appliance starts to heat up again.
– The appliance switches off automatically if it has not been used for another 10 minutes after it enters the standby
mode. The light in the on/off button goes off.
IMPORTANT – EASY DE-CALC
It is very important to use the EASY DE-CALC function as soon as the EASY DE-CALC light starts to flash and the
appliance beeps continuously.
To Next Page
Loading...
