Philips PM 5326 - 1.2. TECHNICAL DATA

TECHNICAL DATA
General information:
On delivery from the factory, the instrument complies with the safety regulations of measuring and
control equipment. The information and warnings contained in this instruction manual must be followed
by the user to ensure safe operation and to maintain the instrument in a safe condition.
- Only data with indicated tolerances or limits are guaranteed; data without tolerances are given only
for guidance.
- All specifications will be met after a warm-up time of 30 min. when keeping the instrument in a
constant mounting position.
-
Inaccuracies (absolute or in %) relate to the indicated reference value.
SPECIFICATIONS
R F Generator
Frequency range
Ranges
Frequency display
Error of the display
Temperature coefficient of the display
Temperature coeffiecient of the frequency
1.2.2. R F Sweep generator
Ranges
wave form
1.2.3. RF output
Attenuator
0,l
- 125 MHz
0.1 - O,25 MHz
0,25 - 0,5 MHz
0,5 - 1 MHz
1 - 2,5 MHz
2,5 - 5 MHz
5 - 10 MHz
10 - 25 MHz
25 - 50 MHz
50 - 125 MHz
5-digit LED display, red, 11 mm high;
3 decimal points;
2
LEDs for dimension
kHz, MHz
< typical, +I digit
+5 x 1
O-~/OC at 23 OC f 20 OC
-
< 1 0-51°c
.4/.5
MHz
1011 1 MHz
36/41 MHz
7511 10 MHz
semi-rectangular
for all RF ranges and all sweep ranges
Connection: BNC connector RF OUT
Impedance: 75
G?
max. output voltage: 50 mV into 75 G?
Frequency response:< 2 2 dB (1 dB typ.)
for all RF ranges
> 100 dB total
0
- 80 dB continous
3 dB, 40 dB calibrated