FEATURES (CONT’D)
Coaxial Cable - A single cable with a metal connector that screws (or pushes) direct-
ly onto a 75Ω jack (ANT(enna) In jack) on the Television or VCR.
Display - Allows the user to quickly confirm what channel number is being viewed
currently.
Jack Panel - The area on the back of the TV.
Menu - An on-screen listing of features that are available for adjustments.
On-screen Displays (OSD) - The wording or messages that help you set up features
(color adjustment, channel setup, etc.).
Programming - Adding or deleting channels in the television’s memory. The televi-
sion “remembers’’ only the locally available or desired channel numbers and skips over
any unwanted channel numbers.
Remote Sensor - A window or opening on the front of the TV through which
remote control signals are received.
Twin Lead Wire - The two-strand 300Ω antenna wire used with many indoor and
outdoor antenna systems. In many cases, this type of antenna wire requires an addition-
al adaptor (or balun) in order to connect to the ANT(enna) In jack on the TV.
Volume Indicator - Appears on the TV screen when you adjust the volume.
GLOSSARY
- 7 -
T
o adjust your TV picture
controls, select a channel
and follow these steps.
PICTURE
ADJUSTMENTS
Press the MENU
button, then press the
CH(annel) ▲/▼ buttons to
select a control.
Press the VOL(ume)
B/{ buttons to adjust the
selected picture control.
BRIGHTNESS Press the VOL(ume) B/{ buttons
until the darkest parts of the picture are as bright as
you prefer.
COLOR Press the VOL(ume) B/{ buttons to add
or reduce color.
PICTURE Press the VOL(ume) B/{ buttons until
the lightest parts of the picture show good detail.
SHARPNESS Press the VOL(ume) B/{ buttons
to improve detail in the picture.
TINT Press the VOL(ume) B/{ buttons to obtain
natural skin tones.
Press the
STATUS/EXIT button.
SETUP B
EXIT B
BRIGHTNESS 24
COLOR 31
PICTURE 31
T
his feature enables you to
receive FM radio stations.
FM MODE
Press the FM button on
the remote control to
select the FM mode. The
radio frequency appears on the
TV screen.
The radio frequency indicator
will move or shift while on the
TV screen during normal FM
mode operation.
If you receive a
weak radio signal, you
may change the FM
ANTENNA mode to
INT(internal) or EXT
(external) by following
the steps below.
1) Press the FM button
to exit the FM mode.
2) Press the MENU but-
ton.
3) Press the CH(annel)
▲/▼ buttons to select
SETUP. Then, press the
VOL(ume) B or {
button to continue.
4) Press the CH(annel)
▲/▼ buttons to select
FM ANTENNA. Then,
press the VOL(ume) B
or { button to select
INT or EXT.
5) Press the
STATUS/EXIT button.
SMART
HELP
FM MODE
Press the CH(annel)
▲/▼ buttons until your
desired radio frequency
appears.
FM 88.0MHz
To Next Page
Loading...
Need help?
General