Philips Respironics EE Leak 1 AF541 - Assembly Procedures; Reassembling Mask Components; Symbols Glossary

7
Assembly
Replacing the Mask Elbow
26
1. Push the elbow onto the mask frame until the tabs snap into
place (audible click).
Replacing the Mask Cushion
1. Grasp the sides of the mask cushion, and push it onto the
mask frame z.
Note: Do not pull the under the nose mask cushion by
the cushion nostril opening.
Replacing the CapStrap Headgear
1. Push the CapStrap headgear ball socket onto the forehead
adjuster ball.
2. Press the headgear clips onto the headgear clip posts.
Replacing the Four Point Headgear
1. Push the Four Point headgear forehead pad ball socket onto the forehead adjuster ball.
2. Press the headgear clips onto the headgear clip posts.
Symbols Glossary
Symbol Title and Meaning Reference
Manufacturer
Indicates the medical device manufacturer.
IEC 60878
ISO 7000-3082
Symbol 5.1.1, ISO 15223-1
Prescription device
Caution: U.S. federal law restricts this device by or on
the order of a physician.
-
Humidity limitation
Indicates the range of humidity to which the
medical device can be safely exposed.
IEC 60878
ISO 7000-2620
Symbol 5.3.8, ISO
15223-1
Temperature limit
Indicates the storage temperature limits to which
the medical device can be safely exposed.
IEC 60878
ISO 7000-0632
Symbol 5.3.7, ISO 15223-1
Not Made with Natural Rubber Latex
Indicates that this mask is not made with natural
rubber latex
-
Do not re-use (in the hospital/institutional
environment)
Indicates a medical device that is intended for one
use, or for use on a single patient during a single
procedure.
IEC 60878
ISO 7000-1051
Symbol 5.4.2, ISO
15223-1
Batch code
Indicates the manufacturer’s batch code so that the
batch or lot can be identified.
IEC 60878
ISO 7000-2492
Symbol 5.1.5, ISO 15223-1