Problem Possible cause Solution
System has not cleaned the shaver
in the cleaning chamber is soiled or
Clean the shaver thoroughly
before you continue shav-
ing. If necessary, clean and
(see chapter ‘Cleaning and
maintenance’).
The shav-
er does not
work when I
press the on/off
button.
The rechargeable battery is empty. Recharge the battery
(see chapter ‘Charging’).
is activated.
Press the on/off button for
3 seconds to deactivate the
travel lock.
The shaving unit is soiled or dam-
aged to such an extent that the
motor cannot run. In this case, the
shaving unit symbol, the tap symbol
Clean the shaving unit or
replace it (see chapters
‘Cleaning and maintenance’
and ‘Replacement’).
The temperature of the shaver is
too high. In this case, the shaver
does not work and the exclamation
Switch off the shaver and let
it cool down. As soon as the
temperature of the shaver has
switch on the shaver again.
RQ1285,
RQ1260/21,
RQ1250/21
only: The shaver
is not entirely
clean after I
clean it in the Jet
Clean System.
chamber is soiled.
Empty and rinse the clean-
chamber drops below the minimum
level during the cleaning program, the
program aborts.The cleaning light
and the ‘cleaning chamber empty’
holder returns to its starting position.
between the two lines (see
chapter ‘Cleaning and main-
tenance’).
ENGLISH 63
To Next Page
