Philips S9031/12 - Charging in the Smartclean System

English
44
Charging in the SmartClean system
(S9781, S9031 only)
1 Put the small plug in the back of the SmartClean
system.
2 Put the supply unit in the wall socket.
3 Press to open the SmartClean system cap,
to be able to place the shaver in the holder
('click').
4
Hold the shaver upside down above the
holder. Make sure the front of the shaver points
towards the SmartClean system holder.
5 Place the shaver in the holder, tilt the shaver
backwards and press down the SmartClean
system cap to connect the shaver (‘click’).
Note: The battery symbol starts to ash to indicate
that the appliance is charging. When the battery
is fully charged, the battery symbol lights up
continuously.
1
2
3