Philips S9031/12 - Cleaning the Beard Styler Attachment

English
60
Cleaning the beard styler attachment
S9781 only
Clean the beard styler attachment after each use.
1 Pull the comb o the beard styler attachment.
Note: Grab the comb in the center to pull it o
the beard styler attachment. Do not pull at the
sides of the comb.
2
Rinse cut hairs o the cutting unit with
lukewarm water.
3 Rinse cut hairs o the comb.
4 Remove the cutting unit from the beard styler
attachment. By pushing the cutting unit o the
beard styler attachment, you can remove any
hairs that have accumulated inside the beard
styler. You can also rinse the bottom of the
cutting unit.
5 Rinse cut hairs out of the beard styler
attachment.
6 Carefully shake o excess water and leave the
comb, cutting unit and beard styler attachment
to air-dry before you use them again.
7
When the cutting unit is dry, attach it to the
beard styler attachment.
1
2