EasyManua.ls Logo

Philips Sonicare DiamondClean Smart - Cleaning and Storage; Toothbrush Handle and Brush Head; Charging Accessories; Product Storage

Philips Sonicare DiamondClean Smart
84 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
23
English
Cleaning
Toothbrush handle
1
Remove the brush head and rinse the metal shaft area
with warm water. Make sure you remove any residual
toothpaste.
Caution: Do not push on the rubber seal on the metal
shaft with sharp objects, as this may cause damage.
2
Wipe the entire surface of the handle with a damp
cloth.
Note: Do not tap the handle on the sink to remove excess
water.
Brush head
1
Rinse the brush head and bristles after each use.
2
Remove the brush head from the handle and rinse the
brush head connection with warm water at least once
a week. Rinse the travel cap as often as needed.
Charger
1
Unplug the charger before you clean it.
2
Wipe the surface of the charger with a damp cloth.
Travel case
Rinse with warm water and use a damp cloth to clean
inside of travel case.
Charging travel case
1
Unplug the charging travel case before cleaning.
2
Use damp cloth to wipe the surface of the travel case.
Storage
If you are not going to use the product for an extended
period of time, unplug it from the electrical outlet, clean
it and store it in a cool and dry place away from direct
sunlight.

Related product manuals