Philips SP9871 - Using the beard styler attachment without comb

20
English
1
Attach the attachment to the appliance ('click').
2
Slide the comb straight into the guiding grooves on
both sides of the beard styler attachment (‘click’).
1
2
3
Press the length selector and then push it to the
left or right to select the desired hair length setting.
4
Switch on the appliance.
5
Move the appliance upwards while you exert
gentle pressure. Make sure the front of the comb is
in full contact with the skin.
6
Clean the attachment after use.
Using the beard styler attachment without comb
You can use the beard styler attachment without the
comb to contour your beard, moustache, sideburns or
neckline at a length of 0.5mm (1/32in).
Note: The beard styler is only intended for trimming
facial hair. Do not use it on areas below the neck.
1
Pull the comb off the beard styler attachment.