34
English
Problem Possible cause Solution
I replaced the
shaving heads, but
the display still
shows the
replacement
reminder.
You have not reset
the appliance.
Reset the appliance by
pressing the on/off button
for approx. 7 seconds.
A shaving unit
symbol has
suddenly appeared
on the display.
This symbol reminds
you to replace the
shaving heads.
Replace the shaving heads
(see 'Replacement').
The notification
symbol flashes and
the shaver beeps
while the shaver is
charging.
The appliance is
overheated.
When this happens, the
shaver stops charging
automatically. Charging
continues once the
temperature of the shaver
has decreased to the
normal level after approx.
10 minutes.
The notification
symbol flashes and
the shaver beeps
when I try to shave.
The shaving heads
are soiled.
Clean the shaving heads
(see 'Cleaning and
maintenance').
The notification
symbol flashes and
the shaver beeps
after cleaning the
shaving heads.
The shaving heads
are damaged.
Replace the shaving heads
(see 'Replacement').
Water is leaking
from the bottom of
the appliance.
During cleaning, water
may collect between
the inner body and
the outer shell of the
appliance.
This is normal and not
dangerous because all
electronics are enclosed in
a sealed power unit inside
the appliance.
To Next Page
Loading...
