To Next Page

To Previous Page

Using Your Remote

1. Press and hold down the SETUP

button on the remote until the

red light on the remote control

turns on. Release the SETUP

button. The red light will

remain on.

2. Press and release the desired

device button (TV, DVD, STRM,

AUD) you would like the

code for.

3. Press and release the

ENTER button.

4. Press and release the #1 button.

Count the number of times the

remote light ashes. This is the

number corresponding to the

rst digit of the code. Repeat

the process by pressing the

#2, #3 and #4 buttons for the

remaining digits.

5. Press and release the ENTER

button to exit this mode.

Code Identication

Reset to Factory

Settings

1. Press and hold down the SETUP

button on the remote until the

red light on the remote control

turns on. Release the SETUP

button. The red light will

remain on.

2. Press and release the

MUTE button.

3. Press and release the number #0

button. The red indicator light will

ash twice.

SETUP

88 99

ENTER

Philips SRP2014C/27 User Manual

Questions and Answers: