4 EN
Set up the universal remote
You must rst set up the universal remote
before operating your devices.
Set up by code selection
1 Switch on your device.
2 Press and hold the device selection button
(e.g. TV) for 5 seconds until the red LED
is on.
SAT
BLU S.BAR
MEDIA
3 Look up the 5-digit code for your brand
in the code list. Codes are listed by the
device type and brand name. The most
popular code is listed rst
4 Enter the rst 5-digit code using the digit
buttons.
NFO
5 If the light is off, a valid code is saved.
Otherwise, the light will ash six times, and
then remains on for code re-entry.
SAT
BLU S.BAR
MEDIA
6 Operate the device with the universal
remote. If your device responds correctly,
it means you have entered the right code.
Otherwise, repeat from Step 2, and enter
the second code on the list.
To Next Page
Loading...
