Philips SRP8121G/27 - Controlling Combo Devices

9
Programming Your Remote
• If NO, continue to press and
release the VOL+ button until
the device turns o to test the
other 9 codes from Step 4. Be
sure to wait approximately 3
seconds after each VOL+ button
press to allow the device time
to respond to the code. When
the device turns o, you have
found a code for your device.
Press and release the same
device button pressed in Step
3. This will store the code in the
remote. Go to Step 7.
NOTE:
• The VOL- button can be used to
go backwards through each batch
of 10 codes.
• The red indicator light will ash 2
times after testing the rst or last
code in each batch of 10.
7. Use the remote to turn the device
back on. Test the buttons on
the remote to see if the device
responds as you would expect.
If the buttons do not operate the
device, return to Step 2 and repeat
this process to search for a better
code to operate the device.
8. Repeat this process for each
device you wish to control.
Controlling Combo Devices
Some combo devices (e.g. TV/VCR, TV/DVD,
DVD/VCR, etc.) will require you to set up two
dierent device buttons to control both parts
of the combo device. For example, if you have
a TV/DVD combo, you may need to set up one
code under the tv button to control the TV
and a separate code under the b-ray button
to control the DVD.
1
2
3
4
5
6
7
8
9
0
ENTER
INPUT
Sleep Setup
APPS
MENU
ch
OK
CH–
CH+
VOL–
VOL+
1
2
3
4
5
6
7
8
9
0
ENTER
INPUT
Sleep Setup
APPS
MENU
ch
OK
CH–
CH+
VOL–
VOL+
1
2
3
4
5
6
7
8
9
0
ENTER
INPUT
Sleep Setup
APPS
MENU
ch
OK
CH–
CH+
VOL–
VOL+
SRP8121G_27 EnSp manual v1.indd 9SRP8121G_27 EnSp manual v1.indd 9 5/24/21 6:21 PM5/24/21 6:21 PM