Philips T260XW03V3 - 4.9 Model T420 XW01 V9; 4.9.1 Control Board; Disassembly; Figure 4-41 Control board location

Mechanical Instructions
EN 16 LCD AUO 2k84.
4.9 Model T420XW01V9
4.9.1 Control Board
Disassembly
1. Place the panel face down on the foam bars, and locate the
Control board.
Figure 4-41 Control board location
2. Remove the four screws of the metal cover: start with the
right-down one, then the left-up, one, then the right-up one
and finally the left-down one.
Figure 4-42 Cover screws removal
3. Carefully disconnect the flat cable/FPCs from their
connectors.
Figure 4-43 Unplug FPCs
4. You now can remove the Control Board.
Reassembly
To reassemble, perform all processes in reverse order.
Important: Be sure to insert the FPCs correctly: the black (or
sometimes white) line must follow the edge of the connector
(see figure below).
Figure 4-44 Correct FPC insertion
4.9.2 Inverter Board
These displays have the Inverter Board located on the PSU.
This is a so-called IPB (Integrated Power Board).
I_17791_022.
e
030
4
I_17791_020.
e
030
4
I_17791_021.
e
030
4
I_17791_019.eps
020408