Mechanical Instructions
EN 6 LCD AUO 2k84.
4.2 Model T260XW03V3
4.2.1 Control Board
Disassembly
1. Place the panel face down on the foam bars, and locate the
Control board.
Figure 4-3 Control board location
2. Remove the four screws of the metal cover: start with the
right-down one, then the left-up, one, then the right-up one
and finally the left-down one.
Figure 4-4 Cover screws removal
3. Remove the tape which is used for fixing the FFC and
Control Board connector.
Figure 4-5 Tape removal
4. Carefully disconnect the flat cable/FPCs from their
connectors.
Figure 4-6 Unplug FPCs
5. You now can remove the Control Board.
Reassembly
To reassemble, perform all processes in reverse order.
Important: Be sure to insert the FPCs correctly: the black (or
sometimes white) line must follow the edge of the connector
(see figure below).
Figure 4-7 Correct FPC insertion
I_17790_002.eps
210308
I_17790_003.eps
210308
I_17790_004.eps
210308
I_17790_005.eps
210308
I_17790_006.eps
210308
To Next Page
Loading...
