Mechanical Instructions
EN 8 LCD AUO 2k84.
4.3 Model T315HW01V0
4.3.1 Control Board
Disassembly
1. Place the panel face down on the foam bars, and locate the
Control board.
Figure 4-11 Control board location
2. Remove the four screws of the metal cover: start with the
right-down one, then the left-up, one, then the right-up one
and finally the left-down one.
Figure 4-12 Cover screws removal
3. Carefully disconnect the flat cable/FPCs from their
connectors.
Figure 4-13 Unplug FPCs
4. You now can remove the Control Board.
Reassembly
To reassemble, perform all processes in reverse order.
Important: Be sure to insert the FPCs correctly: the black (or
sometimes white) line must follow the edge of the connector
(see figure below).
Figure 4-14 Correct FPC insertion
I_17791_023.eps
240808
I_17791_024.eps
240808
I_17791_026.eps
240808
I_17791_004.eps
030408
To Next Page
Loading...
