Philips TAT2206BK/00 - Get Started; Charge the Battery; Pair Earphones with Bluetooth Device (First Time)

3 Get started
Charge the battery
Charging
Note
 Before you use your earphones for the rst
time, place the earphones in the charging box
and charge the battery for 2 hours for
optimum battery capacity and lifetime.
 Use only the original USB-C charging cable to
avoid any damage.
 Finish your call before charging the
earphones, as connecting the earphones for
charging will power the earphones o.
Connect one end of the USB cable into
the charging box, and another end into
the power source.
• Charging process is veried by the
LED light on the front panel.
• When the charging box is fully
charged, the light goes o.
Tip
 The charging box serves as a portable backup
battery for charging the earphones. When the
charging box is fully charged, it supports 2
times full recharge cycle for the earphones.
 Normally, a full charge takes 2 hours (for the
earphones or charging box) by USB cable.
The LED on both earphones
ash in white & blue alternately.
The charging box starts charging.
Pair the earphones with
your Bluetooth device
for the rst time
Open the top cover from charging
box.
Make sure that the earphones is
fully charged.
Note
 After powering on, if the earphones cannot
nd any previously connected Bluetooth
device, it will automatically switch to pairing
mode.
The earphones are now in
pairing mode and is ready to
pair with a Bluetooth device
(e.g. a mobile phone)
Turn on the Bluetooth function of
your Bluetooth device.
Pair the earphones with your
Bluetooth device. Refer to the user
manual of your Bluetooth device.