Philips UT102 - Factory reset the earpieces; How to wear

5 Factory reset
the earpieces
How to wear
Low battery level
(earpieces).
Low battery level
(charging case).
Only the rst blue
LED goes on
You will hear
‘battery low’ on
the earpieces.
The white LED
ash twice.
Battery LED indicator on
earpieces status
Battery is fully
charged(earpieces)
The white LED on
the earpieces is o
Battery is fully
charged(charging
case).
The four blue LED
on the charging
case is on.
It will show a battery indicator on
Bluetooth device after connected to
earpieces.
If you encounter any pairing or connection
issue, you can follow the following
procedure to factory reset your earpieces.
On your Bluetooth device, go to the
Bluetooth menu and remove
Philips UT102 from the device list.
Put both earpieces back to charging
case. Both earpieces ashes white led.
Press and hold both earpieces
function button for 4s,until earpieces
ashes twice white led .
To pair the earpieces with a Bluetooth
device, turn on the Bluetooth function
of your Bluetooth device, select
Philips UT102.
Turn o the Bluetooth function of your
Bluetooth device.