29
Settings
Table of contents
8.1.4 Setting editing mode
You can edit an existing recording by overwriting a part of it or adding
a new recording at its end. You can use the Overwrite mode to delete
the existing recording from its current position!
1
In stop mode (start-up screen), press a/MENU for at least two
seconds.
2
Press a to select the recording settings menu Ó.
3
Press h / b to select the function Edit mode.
4
Press the record key, g, to confirm.
5
Press h / b to select if you wish to add a new part to an existing
recording, whether you want to delete a part of an existing
recording and overwrite it, or turn o the function.
X The selected editing mode icon will be displayed.
Å–add a recording
Æ–overwrite a recording
6
Press the record key, g, to confirm.
7
Press the ~ key to exit the menu.
Tip
• Press the ~ key to cancel the operation without saving and
return to stop mode.
8.1.5 Enabling/disabling silent recording
Use this function to turn o display indication, LED status, and the
signal tones during a recording. This allows you to record while there is
no visible indication on the display that a recording is being made.
1
In stop mode (start-up screen), press a/MENU for at least two
seconds.
2
Press a to select the recording settings menu Ó.
3
Press h / b to select the function Silent recording.
4
Press the record key, g, to confirm.
5
Press h / b, to select whether you want to turn the function on
or o.
6
Press the record key, g, to confirm.
7
Press the ~ key to exit the menu.
Tip
• Press the ~ key to cancel the operation without saving and
return to stop mode.
To Next Page
Loading...
