Philips Voice Tracer - 8.1.5 Monitoring During Recording; 8.1.6 Setting Auto Divide; 8.2 Device Settings; 8.2.1 Enabling;Disabling Key and Signal Tones

27Settings
Table of contents
8.1.5 Monitoring during recording
Using this feature you can listen to the current recording using the
headphones (see also chapter 4.5.1 Connecting the headphones, page
16).
1
In stop mode (start-up screen), press MENU for at least two
seconds.
2
Press e to select the LISTEN function.
3
Press h / b ON or OFF, to switch the feature on or o.
4
Press the record key, g, to confirm.
5
Press the j key to exit the menu.
Tip
• Press the j key to cancel the operation without saving and return
to the stop mode.
8.1.6 Setting auto divide
You can automatically divide large recordings, such as a multi-hour
meeting recording. Once the set time has been reached, the device
stops the current recording and automatically starts a new one.
1
In stop mode (start-up screen), press MENU for at least two
seconds.
2
Press e to select the DIVIDE function.
3
Press h / b, to select whether longer recordings are to be
automatically divided after 30 or 60 minutes, or switch the feature
o.
4
Press the record key, g, to confirm.
5
Press the j key to exit the menu.
Tip
• Press the j key to cancel the operation without saving and return
to the stop mode.
8.2 Device settings
8.2.1 Enabling/disabling key and signal tones
1
In stop mode (start-up screen), press MENU for at least two
seconds.
2
Press e to select the BEEP function.
3
Press h / b, to enable/disable the key and signal tones.