Philips X Series - Package Contents; Installation Notes

55BDL3207X
12
2.2. Package Contents
Please verify that you received the following items with your package content:
• LCD display
• Remote control with AAA
batteries
• Quick start guide
• Power cord
• Display Port Cable
• IR sensor cable
• Edge Alignment Kit-1: 1PCS
• Edge Alignment Kit-2: 2PCS
• Edge Alignment Pin: 2PCS
• DB9(female) to RJ12/45 adaptor
• RJ45 cable for daisy chain
• Wire Clamper: 3 PCS
• Gap Mylar: 3 PCS
* The supplied power cord varies depending on destination.
LCD Display
IR Sensor Cable
Edge Alignment Pin
X 2 PCS
Wire Clamper
X 3 PCS
Gap Mylar X 3 PCS
Power Cord
Display Port Cable
DB9(female) to
RJ12/45 adaptor
RJ45 cable
for daisy chain
Remote Control
and AAA Batteries
Quick start guide
Edge Alignment Kit-1
Edge Alignment Kit-2
X 2 PCS
* Dierences according to regions.
Display design and accessories may dier from those illustrated above.
NOTES:
• For all other regions, apply a power cord that conforms to the AC voltage of the power socket and has been approved by and
complies with the safety regulations of the particular country.
• You might like to save the package box and packing material for shipping the display.
2.3. Installation Notes
• Only use the power cable provided with this product. If an extension cord is required, please consult your service agent.
• The product should be installed on a at surface, or the product may tip over. Leave a space between the rear of the product
and the wall for proper ventilation. Do not install the product in a kitchen, bathroom or a place exposed to moisture, failure to
do so may shorten the life of the internal parts.
• Do not install the product where it is 3000m and higher in altitude. Failure to do so may result in malfunctions.