Rear rack and Taillight
1. Remove screws and washers from the bike. Align the holes
on the rear rack to the holes on the frame.
2. Put the washers and screws go right through and into the
holes, then tighten all screws with the tool.
3. If the holes on the rear rack are not perfectly aligned with
the holes on the frame, you may need to force to adjust the
rear rack when tightening the screws.
4. Unscrew the bolts on the taillight. Align the taillight to the
end of the rear rack.
5. Tighten the bolts. Fix the cable of the taillight on the rear
rack with nylon ties.
To Next Page
Loading...
