Changing the Top Speed
You must check your local laws and regulations to determine if
it is lawful to ride this bike on public roads before adjusting
the bike’s top speed. Laws vary by trail, path, and road so be
sure to check in each new location you will be riding.
To change the top speed of the eBike:
1. Access the settings menu by pressing and holding the up
and down buttons of the display simultaneously until the
screen shows “P01”.
2. From here you can cycle through settings by hitting the
power button of the display and adjust the settings by
pressing the up or down buttons.
3. Please go to setting “P08” and change this setting from 100
to 25 (Suppose you want to adjust the maximum speed to no
more than 25km/h).
4. Press and hold the up and down buttons on the control pad
until the main screen is shown once again.
5. Power the bike off by holding the power button to save the
settings you have just changed.
Battery Capacity Display
On the top of the LCD display, a battery indicator bar can be
found which is labeled “energy bar”. This battery indicator
shows the estimated charge left in the bike’s battery. As the
battery depletes, tick marks will begin to disappear according
to approximately how much charge in the battery has been
used. The various charge level indicator states are shown
below. The battery display will flash when there is no charge
remaining.
Note: The energy bar will not always be accurate. The energy
bar updates every few minutes based on the voltage of the
battery. The voltage of the battery will change all the time when it
is worked. When the voltage of the battery becomes larger, such as
on an uphill slope, the voltage will become smaller. So it is normal
for the battery bar to suddenly decrease when it goes uphill.
To Next Page
Loading...
