be aligned so that the once front wheel is installed, the brake
levers are at 45 degrees to the ground.
6. Tighten the screw under the black rubber cover where on the
top of the fork.
7. Align the stem with the front wheel. Tighten the two screws on
the stem.
Pedals
1. It is important to note that pedals are sided. Remember this is
always from the perspective of the rider. Locate the left hand
side/ right hand side pedal, which is marked "L" and "R".
2. The thread on the left hand pedal is reversed. So tighten it
counter-clockwise. Install the left hand pedal into the left crank
arm gently by hand. Then tighten the pedal by a 15mm wrench.
3. The right hand pedal has a normal thread. So tighten it
clockwise. Install the right hand pedal into the right crank arm
gently by hand. Then tighten the pedal by a 15mm wrench.
Seat post
For better pedaling, safety and overall riding comfort, positioning
the seat at the right height is important. The rider's leg length is
used to determine the seat's position. When you pedal, your hips
should remain level and your legs should be almost fully extended
at the boom of the pedal stroke, but not over-extended.
To determine the right seat height, sit on the eBike with one pedal
at its lowest point and place the ball of your foot on the pedal.
Your leg should be almost fully extended with a slight bend at the
knee.
To Next Page
Loading...
