Your new CA controller is a state-of-the art device which was
developed in accordance with the latest available technical
standards. It comes with a number of outstanding features, such
as:
3 LEDs for a clear, readable display of the state of charge
16 mm
2
connector clamps
Temperature compensation
Electronic protection without fuses
Please read this manual carefully taking special note of the safety
and usage recommendations at the end. The manual gives important
recommendations for installing, using and programming as well
as a troubleshooting guide for potential problems with the controller.
The charge controller protects the battery from being overcharged
by the solar array and from being deeply discharged by the
loads. The charging takes place through multiple stages which
include automatic adaptation to the ambient temperature for
optimal charging of the battery.
The controller is intended for use at 12 V system voltage.
The charge controller has a number of safety and display
functions.
Description of Functions
15
To Next Page
Loading...
