Starting up the Controller
System Voltage
20
The controller is intended for use at 12V system voltage.
Battery Type
The controller does not generate an equalization charge, and is
therefore suitable for use with lead acid batteries with liquid
electrolyte (vented battery) and lead acid batteries with solid
electrolyte ('gel' or 'fleece' type).
The controller warms up slightly during normal operation.
The controller does not need any maintenance or service. Remove
dust with a dry tissue.
It is important that the battery gets fully charged frequently (at
least monthly).
Otherwise the battery will be permanently damaged.
A battery can only be fully charged if not too much energy is drawn
during charging. Keep that in mind, especially if you install additional
loads.
Recommendations for Use
To Next Page
Loading...
Need help?
General
