Configuration and startup
105542_en_05 PHOENIX CONTACT 29 / 198
4 Configuration and startup
4.1 Default settings of the wireless module
All wireless modules are configured to the same default settings when delivered or following
a reset at a later stage.
Table 4-1 Default settings of the wireless module
Parameter Setting
RAD-2400-IFS RAD-2400-IFS-JP RAD-868-IFS
Operating mode I/O data (wire in/wire out)
Wireless interface
Net ID 127
RF band 4 2
Encryption Off
Network structure Mesh
Device type Repeater/slave
Blacklisting WLAN channel 6 -
Data rate of the wireless
interface
125 kbps 9.6 kbps
Receive preamplifier Enabled -
Transmission power 18 dBm 20 dBm 27 dBm
By default upon delivery, the receive preamplifier is activated. The transmission power is
set so that the devices can cover the greatest possible distances. Therefore, if the devices
are operated directly next to one another the receiver may become overloaded. In this
case, remove the antennas, increase the distance between the devices and antennas or
reduce the transmission power using the PSI-CONF software.
To Next Page
Loading...
Need help?
General
