Need help?Do you have a question about the Phoenix Contact RAD IFS Series and is the answer not in the manual?
General| Operating Temperature | -40°C to +70°C |
|---|---|
| Housing Material | Plastic |
| Mounting Type | DIN rail |
| Protection Class | IP20 |
| Operating Voltage | 24 V DC |
| Interface | RS-485 |
| Protocols | Modbus |
| Connection Method | Screw terminals |
Guidelines for safe and proper installation, including electrical safety and environmental considerations.
Specific conditions for installing the device in potentially explosive areas (Zone 2).
Overview of the Radioline wireless modules, their features, and frequency bands.
Description of the available I/O extension modules and their capabilities.
Instructions on how to mount and remove the wireless module and I/O extension modules.
Details on how to connect the power supply to the wireless module and system.
Information on configuring and connecting RS-232 and RS-485 serial interfaces.
Default configuration parameters for the wireless module upon delivery or reset.
Description of the different operating modes for signal and data transmission.
Procedure for configuring the network settings using a configuration stick.
Steps for configuring and diagnosing the wireless modules using PSI-CONF software.
Explanation of the status LEDs and diagnostic indicators on the wireless module.
Explanation of frame-based data transmission parameters like TIdleMin and TFrameEnd.
Details on operating the wireless system in PLC/Modbus/RTU mode for serial communication.
Configuration and application of the dual mode combining serial and Modbus communication.
Overview of supported Modbus function codes for data read and write operations.
Detailed description of the RAD-AI4-IFS module, including structure and configuration.
Information on the RAD-PT100-4-IFS module for temperature measurements.
Description of the RAD-AO4-IFS module for analog output signals.
Details of the RAD-DI4-IFS module for digital input signals.
Information on the RAD-DI8-IFS module for digital input signals and pulse counting.
Description of the RAD-DOR4-IFS module for digital relay outputs.
Details of the RAD-DO8-IFS module for digital transistor outputs.
Description of the RAD-DAIO6-IFS module with mixed analog and digital channels.
Overview of the Trusted Wireless 2.0 technology and its features.
Information on different RF bands used by the wireless system.
Essential requirements and considerations for planning wireless communication paths.
Guidelines for selecting appropriate antenna cables and antennas.
Recommendations for proper antenna installation, including placement and polarization.
Guide values for wireless system range based on antenna and data rate.
Definition and calculation of EIRP, including maximum legal limits.
Procedure for performing a loopback test to diagnose serial data transmission issues.
To Next Page
