105542_en_05 PHOENIX CONTACT 185 / 198
B Appendixes
B 1 List of figures
Figure 3-1: Wireless module structure ..................................................................19
Figure 3-2: Basic circuit diagram for the wireless module ..................................... 20
Figure 3-3: Radioline connection station with up to 32 I/O extension modules ...... 20
Figure 3-4: Mounting and removal ........................................................................ 21
Figure 3-5: Connecting cables ..............................................................................22
Figure 3-6: Connecting the power supply .............................................................23
Figure 3-7: Supply via system power supply ......................................................... 23
Figure 3-8: DIP switch ........................................................................................... 25
Figure 3-9: RS-485 interface pin assignment ........................................................ 25
Figure 3-10: RS-232 interface pin assignment (DTE - DCE) ................................... 26
Figure 3-11: RS-232 interface pin assignment (DTE - DTE) ................................... 26
Figure 3-12: Connecting the antenna ......................................................................27
Figure 4-1: I/O data mode .....................................................................................31
Figure 4-2: I/O-to-I/O, wireless, and RS-485 ......................................................... 32
Figure 4-3: Serial data mode .................................................................................33
Figure 4-4: PLC / Modbus/RTU mode ................................................................... 33
Figure 4-5: PLC / Modbus/RTU dual mode ........................................................... 34
Figure 4-6: Configuration using the configuration stick ......................................... 36
Figure 4-7: PSI-CONF software: “Network Settings” ............................................. 39
Figure 4-8: PSI-CONF software: “Wizard, Step 3” ................................................ 41
Figure 4-9: PSI-CONF software: setting the data transmission rate ...................... 41
Figure 4-10: PSI-CONF software: “Individual Settings, Overview” ..........................42
Figure 4-11: PSI-CONF software: “Individual Settings, Serial Port” ........................ 43
Figure 4-12: PSI-CONF software: “Individual Settings, Allowed Parents” ............... 43
Figure 4-13: Diagnostic LEDs on the wireless module ............................................ 44
Figure 4-14: Bar graph for point-to-point connection ............................................... 48
Figure 4-15: Bar graph for point-to-multipoint connection ....................................... 48
Figure 4-16: PSI-CONF software: “Diagnostic, Overview” ...................................... 49
Figure 4-17: PSI-CONF software: “Diagnostic, I/O Status” ..................................... 50
Figure 4-18: PSI-CONF software: “Diagnostic, Serial Port” ..................................... 50
Figure 4-19: PSI-CONF software: “Diagnostic, Network settings” ...........................51
Figure 4-20: PSI-CONF software: “Record diagnostic data, Network diagnose” ..... 51
Figure 4-21: Assignment of digital inputs and digital outputs .................................. 52
To Next Page
Loading...
Need help?
General
