Phoenix Model BULLDOG - Installing the Aileron Servo and Linkages (Low Wing)

Instruction Manual BULLDOG
Installing the aileron servo and linkages (low wing):
1
1 2 3
4 5 6
7 8 9
10 11 12
13 14 15
2
Remove the covering from the aileron servo
box.
Remove the covering.
Using the thread and the collar as a guide.
Install the aileron servo. Tape the servo lead onto the wing.
Mark the hole of the control horn onto
the bottom of the aileron.
Mark the rear of the servo box onto the wing. Remove the covering. Glue the servo box onto the wing.
Install the control horn onto the aileron. Secure the control horn. The aileron linkages.
Tape the servo lead onto the end of the
thread.
Pull out the servo lead.
Remove the covering from the rear of the
aileron servo box.