Phoenix DryMAX XL User Manual

STEP 3
Press the “POWER” button.
STEP 4
Compressor will turn on after 60 seconds. The status bar will pulse green.
STEP 5
When the light bar on the main dashboard is solid green, you are dehumidifying.
AFTER THE JOB
Press the “POWER” button.
Wait for the “POWERING DOWN” timer to finish.
This allows the blower to remove water from the coils and it gives the coils a
chance to warm up so they stop condensing water.
IMPORTANT: Final purge happens at the end of the power down cycle.
The unit will enter “STAND BY” mode.
Unplug the dehumidifier.
Disconnect the condensate hose.
CORD AND HOSE STORAGE
Put the power cord and condensate hose back in the storage pocket on the top of
the dehumidifier.
For DryMAX XL only –
To store the cords in the storage pocket:
Wrap the condensate hose so that it fills the entire space.
Wrap the power cord slightly tighter so that it fits inside the condensate hose.
For DryMAX only –
To store the cords in the storage pocket:
Wrap the power cord tightly first and place in the storage pocket.
Wrap the condensate hose and place on top of the cord into the storage pocket
as far back as possible.
QUICK START GUIDE
DryMAX XL and DryMAX LGR Dehumidifier
TS-1143 11/19 Rev A
USEPHOENIX.COM | 800-533-7533
DryMAX
DryMAX XL

Phoenix DryMAX XL Specifications

General

Brand	Phoenix
Model	DryMAX XL
Category	Dehumidifier
Language	English