PHOENIX METAL PRODUCTS, INC
TL600/TL700 LAVATORY SERVICE TRUCK
34
MAY 2018
CHAPTER 1
SECTION 3 - OPERATION
LAVATORY EQUIPMENT AND TRUCK SERVICING .
(1) EMPTYING OF UNIT
(A) DRIVE THE VEHICLE TO A DESIGNATED WASTE DUMPING SITE.
(B) POSITION WASTE TANK DRAIN OVER PIT FOR OPEN DUMP. FOR CLOSED
DUMP, POSITION VEHICLE SO DRAIN HOSE WILL ATTACHED TO WASTE
NIPPLE.
(C) PLACE TRANSMISSION SELECTOR IN PARK AND SET EMERGENCY BRAKE.
(D) SLOWLY LOWER HANDLE OF WASTE TANK DRAIN VALVE TOWARD THE
OPEN POSITION (DOWN). WASTE TANK HANDLE IS ON THE DRIVER SIDE.
(E) WHEN TANK IS EMPTY - CLOSE VALVE BY RAISING HANDLE TO THE UP
POSITION.
(2) FILLING FLUSH TANK
(A) DRIVE THE VEHICLE TO A DESIGNATED FILL SITE.
(B) POSITION VEHICLE SO THAT THE FILL PORT IS CLOSEST TO FILLING
HOSE.
(C) PLACE TRANSMISSION SELECTOR IN PARK AND SET EMERGENCY BRAKE.
(D) FILL THE FLUSH TANK (DRIVER SIDE). WATCH LEVEL GAUGE LOCATED
NEXT TO FILL PORT. DO NOT OVER FILL. CAPACITY OF FLUSH TANK IS 240
GALLONS FOR TL-600 AND 300 GALLONS FOR TL-700. WHEN TANK IS FULL
REPLACE CAP ON NIPPLE.
Property of American Airlines
To Next Page
Loading...