PHOENIX METAL PRODUCTS, INC
TL600/TL700 LAVATORY SERVICE TRUCK
35
MAY 2018
CHAPTER 1
SECTION 3 - OPERATION
COLD WEATHER OPERATIONS
IN SUB-FREEZING CONDITIONS THE FLUID IN THE TANK AND PLUMBING
CAN FREEZE. IF A FREEZING CONDITION OCCURS THE TANKS AND/OR PLUMBING
COMPONENTS CAN BURST.
THE HEATERS WORK ON 110 VOLT (RESIDENTIAL) CURRENT. THE UNIT MUST BE
PLUGGED IN TO A DESIGNATED SOURCE FOR THE HEATERS TO WORK.
(1) CONNECTING UNIT TO 110 VOLT CIRCUIT
THE FOLLOWING HEATER(S) ARE IN THE HEATER CIRCUIT:
FLUSH TANK IMMERSION HEATER, SPACE HEATER
(A) DRIVE THE VEHICLE TO THE DESIGNATED STORAGE FOR COLD WEATHER
PARKING.
(B) POSITION VEHICLE SO THAT THE DRIVER SIDE REAR PANEL IS LOCATED
NEAR THE OUTLETS FOR 110 VOLT POWER. THESE OUTLETS MUST BE ON
INDIVIDUAL 15 AMP CIRCUITS.
(C) PLACE TRANSMISSION SELECTOR IN PARK, SET EMERGENCY BRAKE AND
TURN ENGINE OFF.
(D) INSERT EXTENSION CORD RECEPTACLES INTO HEATER INLETS
(E) PLUG EXTENSION CORD MALE ENDS IN AT WALL
THIS CONDITION IS NOT COVERED UNDER WARRANTY.
IT IS VERY IMPORTANT TO ANTICIPATE COLD WEATHER CONDITIONS
AND TAKE THE APPROPRIATE TO PREVENT FREEZING OF THE UNIT.
WHEN VEHICLE IS READY TO BEGIN SERVICE IT IS VERY
IMPORTANT TO REMOVE PLUG FROM OUTLET BEFORE
ATTEMPTING TO DRIVE AWAY
Property of American Airlines
To Next Page
Loading...