Phonic MM1202 User Manual

Describes combo connector and MIC/LINE switch functionality.

Explains gain adjustment, overload, and best operating level.

Describes the HIGH EQ band for crispness, sibilance, or hiss.

Details +48V phantom power availability and usage precautions.

Explains selecting input type for microphone or line level sources.

Describes the insert point for external signal processing.

Describes MID and LOW EQ bands for vocals, guitars, and drums.

Explains the 75Hz low cut filter for reducing rumble or hum.

Describes the pre-fader AUX send for foldback or monitor signals.

Describes the post-fader EFX send for external effects.

Explains the peak LED warning for high signal levels.

Describes the pan control for stereo image placement.

Describes the channel fader for mix proportion and level indication.

Explains the M-S switch for simplifying M-S stereo recording setup.

Explains the concept of M-S recording using cardioid and figure-8 microphones.

Explains cardioid microphone characteristics and polar pattern.

Explains figure-8 microphone characteristics and polar pattern.

Describes high impedance inputs for keyboards, drum machines, etc.

Explains matching input sensitivity to different sources like amateur or pro equipment.

Describes the balance control for stereo image adjustment.

Describes line level outputs to external devices like amplifiers or EQs.

Describes the EFX output socket sending signals from the mix bus.

Describes the AUX output socket sending signals from the aux bus.

Describes the control room output jack for control room speakers.

Describes the REC output for tape recorders via RCA sockets.

Describes the 2-track return inputs via RCA jacks.

Describes the knob controlling the EFX send to external effects.

Describes the knob controlling the AUX OUT level.

Describes the slide-switch for master phantom power control.

Describes the LED meter showing master mix levels in stereo or MS mode.

Describes the button to select meter display for headphone or stereo output.

Describes the button to select MS or STEREO mode for the LED meters.

Describes the button to select the signal path for 2T RTN inputs.

Describes the button to feed AUX signal to the control room.

Describes the fader controlling output level to control room and headphone.

Describes the jack socket for headphone output.

Describes the fader controlling the MAIN OUT output level.

Describes the socket for connecting the power supply unit.

Describes the switch to turn the unit power on and off.

Details the step-by-step channel setup procedure.

Illustrates typical connection diagrams for audio sources.

Shows connection diagram for a live band setup.