Phottix Odin - Phottix Strato Compatibility; Strato Receiver Operation; Strato II Multi Interaction; Cross-System Compatibility Notes

En
INSTRUCTION MANUAL
5
Strato series receivers will work as they previ-
ously did: With ashes set in Manual Mode.
1.The Odin TCU set on Channel 1, 2, 3 or 4 and
in any group will trigger Phottix Strato receiv-
ers set on Channel 1, 2, 3 or 4. Other Odin TCU
functions will not aect Strato receivers.
2. When the Phottix Odin TCU is set to Group
A, press the Test button, the Strato receivers
and the ashes on receivers will test re.
3. The Strato II Multi receivers set to the same
channel and compatible group as the Odin
TCU will be triggered. The Odin TCU will not
trigger Strato II Multi receivers on Group D.
Other Odin TCU functions (TTL, Power control)
will not aect Strato II Multi receivers.
4. The Odin TCU set to Channel 1, 2, 3 or 4 in
TTL/Mixed mode (Group A, B and C) and in
Ratio mode (Group A and B) can be compatible
with Phottix Strato II Multi receivers on Chan-
nel 1, 2, 3 or 4 and Group A, B or C.
5. Press the Test button and ashes on Strato II
Multi Receivers will test re in sequence: Group
A, followed by Group B and C.
6. If a group is disabled on the Odin TCU in
TTL/Mixed mode, it will not trigger ashes on
Strato II Multi receivers.
7. Strato and Strato II Multi transmitters will not
trigger Odin receivers.
8. Phottix Odin for Sony TCUs will not trigger
Odin for Canon or Nikon Receivers.
9. Using the Odin TCU in HSS mode may cause
issues with ash sync when using Strato and
Strato II Multi receivers.