“ASSEMBLE INSTRUCTIONS”
STEP 11 –
Seat and Seat Handlebar Assembly
a. Locate and secure the Seat Handlebar (11) on the Seat Frame (10) with two Carriage Bolts (M8xp1.25x50mm)(118)
and two Nylock Nuts (M8)(136). NOTE: Be careful not to pinch the Pulse Sensor Wire 4 (147).
b. NOTE: Four Nylock Nuts (M8x1.25)(136) will be pre-attached on the Seat
Carriage Assembly (9)’s Seat Fixed Stand as the figure shows on the right
c. Remove four Nylock Nuts (M8x1.25)(136) from the Seat Fixed Stand first and
place them in the safe place for the following assembly process
d. Attach the Seat Frame (10) to the Seat Carriage Assembly (9)’s Seat Fixed
Stand and secure with four Nylock Nuts (M8x1.25)(136)
e. Place the Seat (39) on the Seat Frame (10) and secure with four Bolts, Socket Head (M8xp1.25x40mm)(124).
**Make sure the above parts are tightened before moving on to the next page**
NOTE: After assembling the Seat Frame, slightly and gently shake the Seat Frame to test and make sure the Seat
Frame are secured tightly
To Next Page
Loading...