i.MX 93 BSP Manual PD24.1.1 Documentation Rev.: imx8mp-pd22.1.2-51-ga548be7d
2.3 First Start-up
• To boot from an SD card, the bootmode switch (S3) needs to be set to the following position:
• Insert the SD card
• Connect the targets debug console with your host. Use UART1 console on PEB-EVAL-01 for
phyBOARD-Segin and X-37 USB-C debug for phyBOARD-Nash.
• Power up the board
• Open serial/usb port with 115200 baud and 8N1 (you should see u-boot/linux start on the console
Getting Started 10
To Next Page
Loading...