Piaa LP530 - Page 4

-4-
PKI-0007-3
● Whenusingabracketavailableonthemarket,makesuretheboltsyouremovefromthevehicledoes
nothinderitsperformance.
● Donotinstallonanunstablelocation,itmaycomelosewhile
driving.Thismayaffecttheoveralllifeofthebulb.In
addition
itmaydamagethevehicleorthemainbodyofthelamp.
Makesureyouinstallthelamponastableandsecurelocation.
● Donotinstallonavertically-surface(refertheimage
onrighthand).
◆Whenyouhavedecidedtheinstallationmethod……
(1)
Rearrangethebracketaccordingtoyourneeds,
andapplydouble-sidetape(Item3)andone-side
tapeasshowninthediagrambelow.
(2) Holdthelampuptowhereitwillbeinstalledonthe
vehicle.V
erifythegapbetweenthelampand
surroundingobstacles.
Check!
Makesuretheinstallation
positioniscorrectandthe
logowillnotbeupsidedown.
Bracket
Lampbody
Phillipsheaddriver
Double-sticktape
(Item3)
●ランプを市販のテープや両面テープ等で仮止めしてください。
tape
● Temporarilysetthebracketwithtape.
● Makesuretosetpositionproperlybeforepermanently
settingthelamp.Also,
thoroughlycleanthesurfaceof
theinstallationpositionbeforehand.
● Makesuretoremovethetapeglueonthevehiclebody
afterinstallation.
● Makesurethelampcanbeadjustedupanddown
(beammustbeadjustedsothatitshinesatleast
40maheadofthevehicle.)Ifitcannotbeadjusted,
itmustbere-installed.
● Theremustbebetween30mmto35mmoneither
sideofthelamptoallowforproperadjustment.
● Ifusingascrew,makesurethereisadequatespace
betweenthebracketandthelamp(wherescrew
willbeinserted).