ManualP6040 V30Page 6/12
Introduction to P6040 V30
2.3 Intended use
•
The product is used for creating vacuum or
blow.
2.4 Misuse
•
Do not use the product for evacuating solid
content without the use of filter.
•
Do not install or use the product if it is
damaged.
•
Do not install the product in a fully closed
compartment, without ventilation and exhaust
channeling.
•
Do not use the equipment as a stand-alone unit
to fulfill international lifting standards.
•
Do not use blow-off functions or ejector
exhaust for pressurizing components such as
cylinders and/or tank-volumes.
•
Do not use compressed air pressure or electrical
voltage outside the specification.
•
Do not use the product for evacuating liquids.
•
Do not use the product for evacuating
hazardous substances and/or gases without
containing and handling the exhaust flow in a
proper way.
•
Do not use the product if the exhaust is
restricted or blocked.
•
Do not use the product if vacuum and exhaust
port are simultaneously blocked when unit is
generating vacuum.
•
Do not use the product if the compressed air
line is not properly secured.
3. Introduction to P6040
V30
3.1 Manufacturer
Piab AB
P.O. Box 146
SE-18212 DANDERYD
SWEDEN
3.1.1 Identification label
Each unit is identified by a label with identification
information. For any communication with Piab AB or
service centers always refer to the label information.
3.2 Function specification -
On/Off and ES
•
The P6040 Function Valve V30 is used for On/
Off control.
•
The P6040 Function ES Vacuum/Blow uses
a vacuum or pressure switch, depending on
application. Vacuum/pressure level can be
adjusted on the switch (A/E).
•
The working sequence is to start the pump
with the On signal and when the set level is
established, the ES turns the valve off, thus
overriding the On/Off signal.
•
Status of air valve is displayed by the LED
indicator (B).
•
In case the ES switch is not connected, the On/
Off will work as a normal V30.
•
Operating pressure sensing port (O.P).
•
1 year warranty
To Next Page
