EasyManua.ls Logo

PIAGGIO beverly 500 - Troubleshooting Engine Start Issues

PIAGGIO beverly 500
84 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
02_07
4. Make sure that the emergency stop switch «B» is in position «RUN» and the side
stand is up and not engaged.
5. Pull lever «C» of the front or rear brake and then activate the starter button «D».
WARNING
THE AUTOMATIC TRANSMISSION MAKES THE REAR WHEEL TURN EVEN
WHEN THE THROTTLE IS SLIGHTLY TWISTED. RELEASE THE BRAKE CARE-
FULLY AFTER STARTING, AND THEN ACCELERATE GRADUALLY.
CAUTION
DO NOT START-UP THE ENGINE IN CLOSED AREAS BECAUSE EXHAUST
GASES ARE TOXIC.
Difficult start up
In the rare case of engine flooding, to facilitate start-up, it is possible to try to put the
vehicle into action with the gas hand grip partially or completely open. It is however
necessary, once the engine is started, to take your vehicle to an Authorised Service
Centre to determine the cause of this problem and to re-establish the vehicle proper
functioning.
27
2 Use

Table of Contents

Related product manuals