03_36
Periods of inactivity (03_36)
We recommend carrying out the following operations:
1. Clean the scooter thoroughly and then cover it with a canvas;
2. With the engine off and the piston in the bottom dead centre position, remove the
spark plug, and pour into its hole 1 t0 2 cc of the recommended oil. Operate the starter
button 1-2 times for roughly 1 second to turn the engine over slowly, then insert the
spark plug again;
3. Ensure that the fuel tank is at least half full (in order to ensure the total im-
mersion of the fuel pump); spread antirust grease on the unpainted metal parts;
keep the wheels lifted above the ground by resting the chassis on two wooden wedges;
4. As regards the battery, follow the instructions in the "Battery" section.
Recommended products
AGIP CITY HI TEC 4T
Oil to lubricate flexible transmissions (throttle control)
Oil for 4-stroke engines
Cleaning the vehicle
In order to soften the dirt and mud deposited on the painted surfaces, use a low pres-
sure jet of water. Once softened, mud and dirt must be removed with a soft sponge
for bodywork soaked in lots of water and "shampoo" (2-4% of car shampoo in water).
Then rinse abundantly with water, and dry with a shammy cloth. Any polishing with
silicon wax must always be preceded by washing
CAUTION
DETERGENTS CAN POLLUTE WATER. THE VEHICLE MUST BE WASHED AT A
WASH STATION EQUIPPED WITH A SPECIAL WATER PURIFICATION SYSTEM.
60
To Next Page
Loading...
