Oil for 4-stroke engines
03_42
Cleaning the vehicle (03_42)
Use a low pressure jet of water to soften the caked dirt and mud deposited on the
painted surfaces. Once softened, sponge off mud and dirt using a car body sponge
soaked in a car body shampoo and water solution (2-4% of car shampoo in water).
Then rinse with abundant water, and dry with a shammy cloth. For the engine exterior,
use petrol, a brush and clean cloths. Petrol can damage paintwork. Remember that
any polishing with silicone wax must always be preceded by washing.
MAKE SURE THE VENTILATION SLITS ON THE BATTERY COVER SHOWN IN
THE PHOTO, ARE FREE FROM DIRT AND FOREIGN BODIES
CAUTION
DETERGENTS CAN POLLUTE WATER. THE VEHICLE MUST BE WASHED AT A
WASH STATION EQUIPPED WITH A SPECIAL WATER PURIFICATION SYSTEM.
WARNING
THE USE OF A HIGH-PRESSURE WATER JET IS STRONGLY DISCOURAGED
FOR ANY ENGINE CLEANING OPERATION; HOWEVER, IF NO OTHER MEANS
ARE AVAILABLE, IT IS THEN NECESSARY TO:
• ONLY USE A FANLIKE SPRAY JET.
• DO NOT PLACE THE NOZZLE CLOSER THAN 60 CM.
86
To Next Page
Loading...
Need help?
General