56
English
(*) Pursuant to current regulations on the safety of electrical equipment, you must contact a Piazzetta After-Sales Service
Centre or a qualified electrician for all and any work connected with installation, maintenance or servicing that involves access
to electrical parts.
Problem Cause Remedy
The grate does not warm
Quantity of wood less than necessary
for nominal efficiency
Use the quantity of wood indicated in
the instructions (See “Adjusting the
combustion air” paragraph)
Undersized grate for the environment
to be heated
Integrate with another product
Inadequate insulation for the
environment in which the fireplace is
installed
Insulate well with suitable materials
Oversized fresh air intake Decrease the intake section
Too little and only lukewarm air flows
from the outlets
Pipework not insulated Suitably insulate
Pipework too long or with too many
bends
Change the path, complying with the
ventilation kit instruction booklet
Too many branches Change the path
Environment too large for capacity of
the fan and power of the product
Heat fewer rooms or use the stove as
a supplementary source of heat
The fan does not work (*) Incorrect connection to power supply
Correct the connection according to
the assembly diagram
Electronic regulator damaged Replace the regulator
Power failure Power the appliance
Noisy fan (*) Presence of dust or similar in the fan Clean the fan
Vibrations Check fan position
Worn rotating parts
Maintain or replace worn parts
Replace the fan
To Next Page
Loading...
