What to do if my Piazzetta IP 78/58 Pellet stove has a power failure?
When power is restored to your Piazzetta Pellet stove, it will restart automatically. The cleaning phase will activate, and the display will show “CLEANING”. The room fan will run at full speed to distribute stored heat. The stove will then repeat the startup cycle and operate normally at power level 2 with Multifuoco on 2.
How to fix a failed ignition on my Piazzetta IP 78/58 Pellet stove?
If your Piazzetta Pellet stove fails to ignite, it could be due to the flue gas outlet sensor not detecting a temperature increase or a lack of pellet feed. To resolve this, shut down the stove by pressing the ON/OFF key for a few seconds until the warning buzzer stops. The display will show 'CLEANING BRAZIER,' and then 'OFF' once cooled. Empty the grate completely and initiate a new ignition cycle, referring to the LOAD AUGER table in the PARAMETERS MENU. Then, repeat the ignition process.
General| Model | IP 78/58 |
|---|---|
| Category | Pellet stove |
| Efficiency | 92.1% |
| Tank capacity | 18 kg |
| Pellet Hopper Capacity | 18 kg |
| Weight | 140 kg |
| Diameter of smoke outlet | 80 mm |
| Flue Diameter | 80 mm |
| Control | Remote control |
| Power Supply | 230 V |
To Next Page
