4. Another beep indicates that the
measurement has finished, after
which the armband deflates. Systo-
lic pressure, diastolic pressure and
pulse will be shown simultaneously
on the LCD screen. The measure-
ment is then automatically memo-
rised. Only the last measurement is
memorised. It will be automatically
shown when the unit is switched
on again. The measurement is then automatically stored into the pre-designated memory zone. This
monitor will reinflate automatically if the system detects that the cuff needs to be inflated more to
measure your blood pressure.
Note:
1. The measurement has to be taken in a silent room.
2. This monitor automatically switches off approximately 4 minutes after last key operation.
3. If the ON/OFF/START key is pressed before 4 minutes have passed, the cuff will begin to reinate for
a new measurement. If the ON/OFF/START key is held down for 5 seconds the device switches off
immediately.
4. if the ON/OFF/START key is pressed the measurement will be stopped.
Helpful Tips
Here are a few helpful tips to help you obtain more accurate readings:
• Do not measure your blood pressure immediately after consuming a large meal.
• To obtain more accurate readings, please wait one hour after meal before measuring.
• Do not smoke or drink alcohol before measuring your blood pressure.
• You should not be physically tired or exhausted while taking a measurement
• It is important that you relax during measurement.
• Try to rest for 15 minutes before taking a measurement.
• Do not take measurements if you are under stress or tense.
• Take your blood pressure at normal body temperature. If you are feeling cold or hot, wait a while before
taking a measurement.
• Wait about 3 minutes before taking the next measurement.
• Take the measurement in a silent room
• Do not move and do not talk when taking a measurement
Troubleshooting
If any faults should occur during use, please check the following points.
Symptoms Control Correction
No display when the ON/OFF/
START key is pressed
Have the batteries run down?
Replace them with new alkaline
batteries.
Are the batteries positioned the
wrong way round?
Re-insert the batteries in the
correct positions.
EE mark shown on display or the
blood pressure value is displayed
excessively low (high)
Is the cuff placed correctly?
Wrap the cuff properly so that it is
positioned correctly.
Did you talk or move?
Measure it again, staying still.
Keep the wrist steady during
measurement
Was the cuff shaken when
measuring?
Notes:
1. If the unit still does not work, return it to your dealer. Under no circumstance should you disassemble
and repair the unit by yourself.
2. For a guide to the error messages that appear on the display see the instructions on page 16.
Warning
1. Check that the device is intact before using
2. The unit contains high-precision components. Therefore, avoid extreme temperatures, humidity, and
direct sunlight. Avoid dropping or shaking the main unit, and protect it from dust.
3. Clean the blood pressure monitor body and the cuff carefully with a slightly damp, soft cloth. Do not press. Do not
wash the cuff or use chemical cleaner on it. Never use thinner, alcohol or petrol (gasoline) as cleaner.
4. Leaky batteries can damage the unit. Remove the batteries when the unit is not used for a long time.
5. Keep out of reach of children.
6. If the unit is stored near freezing, allow it to return to room temperature before use.
7. This unit is not field serviceable. You should not use any tool to open the device nor should you attempt
to adjust anything inside the device. If you have any problems, please contact the store or the doctor
from whom you purchase this unit.
8. For users diagnosed with common arrhythmia (atrial or ventricular premature beats or atrial brillation),
diabetes, poor circulation of blood, kidney problems, or for users suffered from stroke or for unconscious
users, the device, as all automatic blood pressure monitors, may have difficulty in determining the proper
blood pressure. These users have to consult with their doctor regularly
9. In diabetic patients with general arteriosclerosis the oscillometric measurement is negatively affected by
the hardening of the artery. So in these cases, auscultation results are more precise.
10. To stop the measurement at any time, press one of the buttons under the display. The cuff will
quickly deflate.
11. Once the ination reaches 300 mmHg, the unit will start deating rapidly for safety reasons.
12. Please note that this is a home healthcare product only and it is not intended to serve as a substitute
for the advice of a doctor or medical professional.
13. Do not use this device for diagnosis or treatment of any health problem or disease. Measurement
results are for reference only. Consult a healthcare professional for interpretation of pressure measure-
ments. Contact your doctor if you have or suspect any medical problem. Do not change your medica-
tions without the advice of your doctor or healthcare professional.
To Next Page
Loading...
