Picberm PB2210 - User Manual

Questions and Answers

T
Thomas SmithAug 5, 2025
Why does my Picberm PB2210 Juicer stop during operation?
- P
  Patricia CarterAug 5, 2025
  If your Picberm Juicer stops during operation, it could be due to several reasons. First, check if the voltage is too low. If not, you might be overloading the juicer with too many ingredients; disconnect the power and remove some of them. Also, avoid pressing the pushing rod too hard; use a light touch. Lastly, the motor may be overheating; switch off the juicer for 20-30 minutes to allow it to cool down before using it again.
W
Wendy JohnsonAug 9, 2025
Why is my Picberm Juicer making abnormal vibrations or loud noises?
- M
  Molly AustinAug 10, 2025
  Abnormal vibration or loud noise in your Picberm Juicer can be caused by several factors. Ensure the juicing sieve is correctly and evenly installed. Make sure the juicer is placed on a smooth, steady surface, and that its foot pad is securely in place. Check if the voltage is too high. If you are using excessive ingredients, disconnect the power and remove some of them.
J
johnjonesAug 15, 2025
What to do if the cutter of my Picberm PB2210 Juicer is obstructed?
- J
  Juan EstradaAug 15, 2025
  If your Picberm Juicer cutter is obstructed, it's likely due to the cutter being twined by ingredients or deadly locked. To resolve this, disconnect the power, take the ingredients out, and cut them into smaller pieces before re-juicing.
J
Joseph StevensonAug 20, 2025
Why does only a little fruit juice come out of my Picberm PB2210?
- B
  Briana BeltranAug 20, 2025
  If only a little fruit juice comes out of your Picberm Juicer, it could be because too much pomace has accumulated in the center ring. Try cleaning the center ring. Also, avoid exerting large pressure on the pushing rod; press it lightly.
G
Garrett CrossAug 25, 2025
Why does fruit contain so much pomace after using my Picberm PB2210 Juicer?
- L
  Leslie CardenasAug 25, 2025
  If your fruit contains much pomace after using the Picberm Juicer, it may be due to a broken juicing sieve. Replace the broken juicing sieve. Alternatively, too much pomace might have accumulated in the center ring, so replace the center ring.
J
Jeremy MorrisonAug 29, 2025
How to fix a Picberm PB2210 Juicer that doesn’t work after switching it on?
- S
  sherri83Aug 29, 2025
  If your Picberm Juicer doesn’t work after connecting the power and switching it on, it might be due to the center ring or top cap not being installed correctly. Ensure the center ring and the top cap are properly in place. If the issue persists, the microswitch might be broken, consider replacing the top cap. Make sure all parts are in place.