PICO PicoScope 3000 A Series Programmer's Guide

PicoScope 3000A Series Prog rammer's Guide 89
Copyright © 2011-2013 Pico Technology Limited. All rights reserved. ps3000abpg.en r9
triggerSource, the source that will trigger the signal generator:
PS3000A_SIGGEN_NONE
run without waiting for trigger
PS3000A_SIGGEN_SCOPE_TRIG
use scope trigger
PS3000A_SIGGEN_EXT_IN
use EXT input
PS3000A_SIGGEN_SOFT_TRIG
wait for software trigger
provided by
ps3000aSigGenSoftware
Control
PS3000A_SIGGEN_TRIGGER_RAW
reserved
Arguments
If a trigger source other than P3000A_SIGGEN_NONE is specified,
then either shots or sweeps, but not both, must be non-zero.
extInThreshold, used to set trigger level for external trigger.
Returns
PICO_OK
PICO_BUSY
PICO_POWER_SUPPLY_CONNECTED
PICO_POWER_SUPPLY_NOT_CONNECTED
PICO_INVALID_HANDLE
PICO_SIG_GEN_PARAM
PICO_SHOTS_SWEEPS_WARNING
PICO_NOT_RESPONDING
PICO_WARNING_AUX_OUTPUT_CONFLICT
PICO_WARNING_EXT_THRESHOLD_CONFLICT
PICO_NO_SIGNAL_GENERATOR
PICO_SIGGEN_OFFSET_VOLTAGE
PICO_SIGGEN_PK_TO_PK
PICO_SIGGEN_OUTPUT_OVER_VOLTAGE
PICO_DRIVER_FUNCTION
PICO_SIGGEN_WAVEFORM_SETUP_FAILED
PICO_NOT_RESPONDING

PICO PicoScope 3000 A Series Specifications

General

Brand	PICO
Model	PicoScope 3000 A Series
Category	Test Equipment
Language	English