The Intelligent Transmitter – Gives maximum support in SEND-mode
In SEND-mode there are functions working in the background of PIEPS DSP PRO/DSP SPORT that
help to be found faster and more efciently in case of an emergency.
Auto-Antenna-Switch
If the transmitting antenna is negatively inuenced through external devices (i.e. mobile phone), the
range of receiving beacons is directly inuenced (reduction up to 30% and more).
maximum range to the receiving beacon!
iPROBE-Support
The PIEPS iPROBE ONE is an electronic probe with an automatic deactivating function and an
optical and acoustic target indicator. The PIEPS iPROBE ONE deactivates the strongest signal of all
beacons with iPROBE ONE Support*. Signal overlap is eliminated and the next strongest signal is
automatically shown on the display of the receiving beacon (without reduction of range!) The PIEPS
iPROBE Support gives maximum assistance to multiple burial situations!
*Beacons with iPROBE ONE Support: PIEPS VECTOR, PIEPS DSP PRO, PIEPS DSP SPORT, PIEPS
DSP (with Software version 5.0 or greater), PIEPS DSP Tour, PIEPS FREERIDE
More information can be found on www.pieps.com.
SEND-MODE
Press the main switch lock and push the main switch to the “SEND“
position. The display indicates the SEND-symbol, the remaining
battery capacity, and the transmitting antenna. Additionally an LED
indicator light ashes simultaneous with the transmitter bit timing.
When you are on a tour, make sure the “SEND“-mode is selected
throughout. The PIEPS DSP PRO/DSP SPORT will transmit a
continuously dened signal (457kHz) that can be picked up from all
other avalanche beacons (according EN300718).
To Next Page
Loading...
Need help?
General
